Overview:
The centrifuge we produce if special equipment for separating the solid from the liquid. The machine has suitability for different well drilling procedure and high process capacity. It can separate out the ultra micro harmful solid-state grains in the drilling mud. At the same time, the transporter blade in this machine is inlaid with hard alloy block that elongates its service life considerably.
Installation, use and maintenance:
1, Centrifuges to be installed on top of the new entrance to the 3rd tank away from the drilling pump, can also be arranged according to the actual situation.
2, Frequently check the fasteners are tightened, and lubrication of lubricating parts.
3, The top-long centrifuge should be cleaned rollers and conveyor to have a confirmation no jamming before boot.
4, Machine operation should idling for 10-15 minutes, confirm centrifuge normal operation, then open the pump for a small to large amount of slurry, adjusted to a suitable date.
5, if the drilling fluid viscosity is too high, should be appropriately adding dilution water, to reduce viscosity, to accelerate the solid phase precipitation speed, improve the processing capability of the centrifuge.
Technical Parameters:
|
Model |
Bowl Speed r/min |
Treating Capacity m³/h |
Separation Point µm |
Main motor kw |
Back motor kw |
|
GLW450-NY |
2600 |
50 |
2.5-5 |
30 |
5.5 |
|
GLW400-NY |
3200 |
60 |
2 |
30 |
7.5 |
|
